Brush Mowers

Home > Tractor Attachments > MOWING > Brush Mowers

Sort By:

Page of 1


BRUSH MOWER - BCS Retail Price: $1,699.00 Dailey's Farm Price: $1,614.00 Seasonal Sale Price: $1,529.00 Savings: $170.00		Bellon Brush Mower Retail Price: $1,699.00 Dailey's Farm Price: $1,595.00 Savings: $104.00

This brush mower made by Del Morino of Italy for BCS, has been around for 2 decades. Its a very good brush mower and can take abuse. It has a steel reinforced Aluminum gearbox, Hardened gears with shafts supported by ball bearings in oil bath. Input shaft has a swivel built into it that allows the mower to "float" independant of tractor axle, and follow the contour of the ground on rough/uneven terrain. Cut material is released under a rubber flap in the rear. Front rubber flap and metal "lip" is adjustable for users needs. It can be moved up or down with a couple of bolts. Moving it upward "opens" the front of the mower and allows much more volume of material under the mower more easily. Cut height on this mower is 4", non adjustable. *Accessory Note:* We recommend a minimum of 5" x 10" x 20" with any brush mower. But 5'' x 12'' x 22" wheels (or larger) are optimal. This does depend upon tractor model. The extra wheel height will provide more ground clearance for the engine that is needed in rough areas.		The importer calls this a "Super-duty" brush mower, due to the following features: Cast-Iron gearbox housing with hardened steel gears and ball bearings in oil bath. Input shaft housing is designed with an oscillating swivel so that deck “floats”, or follows the contour of the ground, independent of the tractor axle, and also has “leveling springs” to help offset the torque of the PTO shaft through this swivel. Cut material comes out under series of hanging chains (just like a BIG bush-hog — chains never dry-rot or need replacement!) in the rear of mower. Front mower "opening" of this mower is NOT adjustable like the BCS, however the size of the opening is good and this is not a problem. Cutting height adjustable from 2.5 to 4” by moving the skids up or down with 4 nuts. (Although, to meet current safety standards for brush mowers, the blades must cut at 4” high. So, if you adjust for a lower cutting height, it is at your own risk!!) Blades are designed to be flipped over, for more life. Blade carrier disk even comes with 2 extra blade-mounting holes, so if you bash into enough rocks enough to deform the original set of holes, you can just move to the “spare” holes. *Available Sizes: 28" to fit both BCS and Grillo (G110)* *Accessory Note:* We recommend a minimum of 5" x 10" x 20" with any brush mower. But 5'' x 12'' x 22" wheels (or larger) are optimal. This does depend upon tractor model. The extra wheel height will provide more ground clearance for the engine that is needed in rough areas.